![]() Applying a layer of top coat can aesthetically change the look of your kit. You finished your model kit, and it looks great, but let's say you want to take it a step further. We suggest using the limonene version for a more lemon scent, but you should still be careful to not breathe so much of the chemical in. Most importantly! Please do this in a well-ventilated area open a window or a door. Repeat the process on other parts and you'll have a seamless Gunpla. Start with lower grit and work your way up to higher grit sandpaper to polish the piece. After allowing the glue to bond, you will need to sand the side down to make the part flush. Step 3: After adding the cement, seal back up the part and SQUEEZE the two halves together until dry This will allow the glue to melt the plastic and bond the two parts together.Depending on the type of cement, the glue may dry quicker, so several coats may be needed. Step 2: Add a coat of the hobby cement on the edges where you want the seam to be removed.Step 1: Pry open the part or if you're building it along the way, add the polycaps (if needed).Sanding Paper (400-600, and 1000+ for polishing)Īfter acquiring your tools, you simply select which parts you want to remove the seam from.Hobby Cement (We suggest limonene type).Here's our helpful tip to help you remove those seams and make your kit look flush. Some may want to enter a contest and removing the seams will give it a better aesthetic look. For others, those lines can be jarring and would prefer to remove them. This is perfectly fine, because it is to be expected. Whenever you finish a kit right out the box, seam lines are found all throughout the kit. If the black ink is too bold to your liking, both mediums can also be found in a gray color, which is better suited for mobile suits that have more white parts. An eraser can also get the job done once the ink has dried. Use a cotton swab to remove any excess ink you don't want thick lines. You then take your cotton swab and remove excess.įor markers: Uncap the marker and run the pen down the line. Then you lightly touch the panel line, and watch the ink run through it. Once you've found the part(s) you want to panel line, grab your ink or marker.įor ink bottle: Unscrew the cap (most have a brush attached to the cap) and remove some excess ink on the brush. You'll also need a cotton swab or a eraser to wipe any excess ink.įirst is to give an overall look at your kit, and where you'd like to panel line. There are several ways to apply ink onto your kit, one method is using ink, and the other is using a panel line marker. These grooves give the kit more detail, and with a proper application of ink, you can heighten the overall aesthetic look of your Gunpla. What is a panel line? They are those shallow grooves found all over your kit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |